| 1. | The loading ratio was climbed to 0 . 6 in a relatively short time
在较短的时间内充氢率很容易达到0 . 6 。 |
| 2. | Standard guide for determining load ratios for technical rescue systems and equipment
技术救援系统和设备的荷载率测定的标准指南 |
| 3. | Load ratio uster
带负载电压蝶器 |
| 4. | Probe into the dynamic fracture toughness of marble using the energy method in medium load ratio
用能量方法探索测量中等加载速率下大理岩动态起始韧度问题 |
| 5. | Influences of load ratio , materials strength and ratio of reinforcement on seismic reliability of beams were analyzed
研究了荷载比值、材料强度等级和配筋率对梁可靠度的影响。 |
| 6. | The result of this method agrees well with that estimated by fem . load ratio coefficients a and p are important to calculate vertical stresses
本文分析了、对下卧层附加应力的影响并讨论了荷载分配系数、的计算方法。 |
| 7. | The axial load ratio influenced the cantilever columns behaviors significant , the larger axial load ratio was , the lower ultimate load and worse ductility was shown
轴压比在较小的时候可以提高钢管混凝土的承载力，当轴压比较大时，其承载力显著降低，延性也较差。 |
| 8. | At a temperature range of the ambient temperature ~ 400 c and 100pa ~ 1000pa pressure we found the optimal condition to improve the loading ratio in palladium wire by gas - loading method
摸索出温度在室温400压力在100pa 1000pa条件下，气态充氢和提高钯丝充氢率的条件。 |
| 9. | ( 3 ) the cfdst beam - columns were tested under constant compressive axial load and cyclic lateral load . the main parameters varied in the tests are axial load ratio and hollow section ratio
( 3 )以空心率和轴压比为主要变化参数,进行了压弯构件在往复荷载作用下的试验研究。 |
| 10. | The he - ne laser with the wavelength of 632 . 8nm , when was interacting on the pd wire , which loading ratio is 0 . 6 , we gain the apparent " excess heat " by the excitation
而且，在he - ne激光器发出的波长为632 . 8nm激光的照射作用下，在充氢率为0 . 6时，曾一度观测出明显的“过热”现象。 |
